I made some low profile Chevy
spring hangers for my rear springs. The design is loosely based on a picture I saw on Pirate4x4. I have to say that if I did it again I would just french them in to the frame. That may be something that I do in the future to lower the truck more.
spring hangers for my rear springs. The design is loosely based on a picture I saw on Pirate4x4. I have to say that if I did it again I would just french them in to the frame. That may be something that I do in the future to lower the truck more.They are made from 3.5x3.5x0.25" square tubing and 1/4" flat stock.
and 1/4" flat stock.The slope is so that they glide over rocks with little resistance, and believe me that has been tested and prooven.
The cutout is so that the spring will sit even lower, it's only 1/4" but every bit counts.
No comments:
Post a Comment